View Single Post
Old 25th Dec 2019, 3:40 pm   #5
Argus25
No Longer a Member
 
Join Date: Oct 2016
Location: Maroochydore, Queensland, Australia.
Posts: 2,679
Default Re: Copper anti-corrosion experiments

Quote:
Originally Posted by G6Tanuki View Post
Is the Servisol product-range available where you are?
I may be able to get some. If anyone has some, and a perfectly clean copper plate, it would be good to wipe a film over it and wait 2 weeks and see what happens.

My original experiments with the WD-40 involved a brass sheet with two bare steel nuts screwed to it, one as a control, put outdoors in a rain protected area. I found that the rust on the steel was very well inhibited by the WD-40, but it produced spotty corrosion on the brass. Then I tried a range of metals and found copper the most sensitive to the effect and the brown spot effect is seen indoors after 10 days to 2 weeks. So far there is still no issue detected with the RP7 or Inox mx3. I'm also repeating the experiment with a much thicker coat of RP7.

Last edited by Argus25; 25th Dec 2019 at 3:45 pm.
Argus25 is offline