Re: Soldering Iron For PCB's
JBC all the way for me! Tried a Metcal recently, didn’t like it. I used to use Metcals years ago when I was an apprentice mobile phone tech, thought they were pretty good back then, but then I got hold of a JBC, and it’s just so much better. I also have a Maplin temperature controlled iron, that is pretty good but takes ages to heat up, good iron for use on PCB’s, and for a cheap iron it’s pretty good. Before that I had a 25W Antex which was ok, no temperature control though. Sad thing about the JBC’s is the need for deep pockets!! They are not cheap at all.
Regards
Lloyd
|