Re: Using hole punches on die cast boxes
I've used q max cutters and step drills with no problem on die cast boxes and aluminium.
However on thicker materials (2mm) I find the diameter of the hole is slightly different on each side when using a step drill as even they have a small taper.
I only use cone drills / reamers for de-burring.
Never in 50 years of using q max cutters have I had trouble punching holes in die cast boxes plus I'm still using the same q max punches - must have been well made !
I always use step drills at the minimum speed in my drill press.
Regards Tim
__________________
Building and tinkering for over 50 years, from 807's to digital amateur TV.
|