UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Revox A77 Stops Playing (Transport Fault)

NorfolkDaveUK · 18th Nov 2018, 12:13 am

I use clip ins and glue them to the board , no problems so far.

2200uF 50v is the modern equivalent I`m using . Vishay are the brand I`m using I think .

You can use a 3300uF 35v if you want to go up rather than down but the 2200`s are close enough and work just fine . You can go to around double the capacitance of a electrolytic before problems start occurring but you dont want to go too far under .

18th Nov 2018, 12:13 am	#49
NorfolkDaveUK Banned Join Date: May 2018 Location: Norwich, Norfolk, UK. Posts: 605	Re: Revox A77 Stops Playing (Transport Fault) I use clip ins and glue them to the board , no problems so far. 2200uF 50v is the modern equivalent I`m using . Vishay are the brand I`m using I think . You can use a 3300uF 35v if you want to go up rather than down but the 2200`s are close enough and work just fine . You can go to around double the capacitance of a electrolytic before problems start occurring but you dont want to go too far under . Last edited by NorfolkDaveUK; 18th Nov 2018 at 12:27 am.