View Single Post
Old 5th Nov 2017, 9:03 am   #18
dseymo1
Retired Dormant Member
 
Join Date: Dec 2007
Location: Shropshire, UK.
Posts: 3,051
Default Re: Sockets on a roll

I think the idea was to cut the inlet to be a tight fit over the cable. There's a degree of elasticity in the housing to allow the cable to be pulled through, but I remember that it was much easier to feed it from the inside, as you'd expect. These days, I'd probably use a smear of silicone grease too.
dseymo1 is offline