View Single Post
Old 13th May 2021, 2:02 pm   #18
DMcMahon
Dekatron
 
DMcMahon's Avatar
 
Join Date: Apr 2019
Location: Worthing, West Sussex, UK.
Posts: 3,610
Default Re: Help getting Motor to Run on TK20

Yes have noticed before that some TKs that normally operate in the horizontal position do not like operating vertically, as you say if operated vertically the flywheel tends to move to the heads mounting plate. There is normally quite a bit of vertical play/end float on the flywheel shaft with the bottom of the shaft siting on a ball bearing in the lower bearing housing.

David
DMcMahon is offline   Reply With Quote