Re: Transformer Question
If this refers to the Brimar VA11 amplifier on your ECC807 thread, then you could simply use the two diodes and centre tap to 0 volts idea (that is a 'full wave' rectifier). The current available will be what ever the transformer is rated at. Yes you will get 400+ volts DC, but that is what is needed?
For information, if you did parallel the two 300 volt windings do not assume you would get 2 x the current. Unless the transformer is rated for use in bridge mode best to estimate 2/3 the 'total' current.
__________________
Never Leave Well Enough Alone...
Last edited by snowman_al; 24th May 2020 at 9:21 am.
Reason: circuit added
|