Re: Brenell Purchases
Mk. 5 Update:-
While removing the valve screening cans as above noticed that the front panel tone control has an on/off mains switch, which I believe is not standard build. There also is a 6 way chocolate strip terminal block near the tone control where various wires from the tone control go to (mains cable and screened cables I think). The cabling from the terminal strip go into the back of the unit, the mains cable presumably to wire into the standard mains on/off switch circuit on the power supply but no idea where the other cables would go to.
I cannot see any of this on the Mk. 5 schematic, so guess it is a modification.
Some of the cabling is in a poor state with rubber insulation decomposing so will probably remove (once I check out exactly what it is) all this cabling once I start looking at the Mk. 5
|