UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

NorfolkDaveUK · 28th Sep 2018, 3:03 pm

So I`ve been at this all morning trying to figure out why I can get these values to make any sense , the only way I can configure this to the spec the manual is asking for is to use peak to peak values . How do you determine if you are supposed to use peak , RMS or peak to peak ?

Thanks

28th Sep 2018, 3:03 pm	#4
NorfolkDaveUK Banned Join Date: May 2018 Location: Norwich, Norfolk, UK. Posts: 605	Re: N4510 help needed So I`ve been at this all morning trying to figure out why I can get these values to make any sense , the only way I can configure this to the spec the manual is asking for is to use peak to peak values . How do you determine if you are supposed to use peak , RMS or peak to peak ? Thanks