UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

NorfolkDaveUK · 27th Sep 2018, 1:05 pm

So I`m back to this again . I`m trying to follow the setup procedure but I`m struggling right from the off .

I`m inputting 333Hz @ 330mv and at the monitor I should be able to adjust it down to 1v however I can`t get it lower than 2.5v rms any ideas what might be causing this ? I suspect this is why the input on this thing is uber hot the scope is also not showing the 333hz coming out its showing 50hz coming out .

27th Sep 2018, 1:05 pm	#1
NorfolkDaveUK Banned Join Date: May 2018 Location: Norwich, Norfolk, UK. Posts: 605	N4510 help needed So I`m back to this again . I`m trying to follow the setup procedure but I`m struggling right from the off . I`m inputting 333Hz @ 330mv and at the monitor I should be able to adjust it down to 1v however I can`t get it lower than 2.5v rms any ideas what might be causing this ? I suspect this is why the input on this thing is uber hot the scope is also not showing the 333hz coming out its showing 50hz coming out .