Re: PCB Artwork transfer
Hi Argus. It looked so simple on the video, but on a closer look, he does not do large areas of ground, and as you say close tracks are a problem too.
I think its a "bin it" situation.. it would have been nice to make a couple of extra PIC Controller and DDS boards for "stock"....
I was thinking about the iron technique......... I had tried it previously using a glossy mag paper, and I wondered if the target material needs pre heating, to negate the heat being dissipated too soon..I will give it one last go before I revert to my method I have used for years.
__________________
Should get out more.
Regards
Wendy G8BZY
|