View Single Post
Old 9th Sep 2019, 2:38 pm   #31
crackle
Dekatron
 
crackle's Avatar
 
Join Date: Mar 2011
Location: Basildon, Essex, UK.
Posts: 3,881
Default Re: Kolster-Brandes MR10

Have you got the KB service manual from my web site, have a look at page 8, this should cover the version you have.
The anode resistor for the V2 6U8 (ECF82 in your case) pentode section is shown as 47K, By the way all the voltages on that circuit diagram are what I actually measured on my radio, I added them to the schematic just as a reference point.
I tend to not worry too much about resistors at this stage, until after I have replaced all the horrible hunts. Then change what's required after checking the voltages.

Mike
__________________
BVWS Member, 2E1MJE
The KB Museum

My collection in the Radio Museum
crackle is offline