View Single Post
Old 10th Aug 2018, 10:20 am   #62
dseymo1
Retired Dormant Member
 
Join Date: Dec 2007
Location: Shropshire, UK.
Posts: 3,051
Default Re: Oil for sintered bearings

An approach I have taken in the past, but hesitate to recommend unless you are sure you can do it safely, is to loosely reassemble the motor, then power it up and carry out final asembly while it is running. It will tend to self-align, and any problems due to unevenly torqed fixings, for example, are immediately evident.
dseymo1 is offline