Re: Knob casting experiments
I was casting prosthetics using a blue silicone for the molds and a 2 part colorable plastic for the fangs, knobs, etc.
I did find that temperature made a massive difference on the curing time, and it was recommended putting the item in a vacuum chamber to pull out all the air bubbles.
Not having one, I used an industrial strength body vibrator to agitate the air bubbles out. It worked great. I would think that a vibrating sander strapped to the board that the mold was on would work quite well too.
Casting is difficult under good conditions. My hat is off to you.
|