View Single Post
Old 28th Jun 2020, 3:59 pm   #1
Robert Gribnau
Hexode
 
Join Date: May 2017
Location: The Hague, The Netherlands
Posts: 272
Default Guitar amplifier with 2 x EL86 push-pull

Hello all,

I have just finished and tested the electronic part of a guitar amplifier. All that is left to be done, is making and installing the bottom plate (MDF with an aluminum cover on the amplifier side as a screen).

Because the figures for a pair of EL86's in push-pull are a little bit better than those for a pair of EL84's in push-pull, I wanted to build an amplifier using EL86's for some time now.

One of the design problems was to keep the needed 200 V supply voltage for the screen grids of the EL86's constant (enough) while the anode supply voltage has to be 250 V. The screen current varies from 4 mA (no signal) to 26 mA (full power). Dropping the 250 V to 200 V with a resistor would cause to much voltage sag. But by using two ZZ1040 voltage stabiliser tubes i solved this problem.

The amplifier works very well. No noise at all with the volume turned down and very loud when turned up. And the ZZ1040's give off a lovely bright-purple glow which diminishes a bit when you give the guitar a good 'hit'. I can not wait to see how it will look after sundown.

Edit: Because the schematic is hard to make out, a link to the schematic on my internetsite: https://1.bp.blogspot.com/-SwqQZAEWU...600/Schema.png

Greetings,
Robert
Attached Thumbnails
Click image for larger version

Name:	DSC05264.jpg
Views:	180
Size:	99.8 KB
ID:	209733   Click image for larger version

Name:	DSC05267.jpg
Views:	177
Size:	85.9 KB
ID:	209734   Click image for larger version

Name:	DSC05266.jpg
Views:	168
Size:	98.5 KB
ID:	209736   Click image for larger version

Name:	Schema.jpg
Views:	154
Size:	72.3 KB
ID:	209739  

Last edited by Robert Gribnau; 28th Jun 2020 at 4:27 pm.
Robert Gribnau is offline