I had to rather demolish the tape counter in order to get into it to clean it. There are two screws underneath the cardboard printed face - in heating it up to try to dislodge the press-fit body, as I thought, I melted the cover! Time to make a new acrylic dial glass. Out with the holesaw!
Then a nicely scrubbed-up switch, and a horribly dusty loudspeaker. There's been a lot of elbow-grease and hot water gone into this project so far! Don't worry, not on the speaker cone!
Friday night - time for the last motor lubrication, and
The other night I did start to pick up my jar of remarkably malt-looking ISO100 oil instead of my glass of whisky... I need to remember to put a lid on!