UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

barrymagrec · 9th Nov 2018, 4:32 pm

If this is the model I think it is I seem to remember that it takes bits that are virtually identical in size to the TCP bits but without the magnetic slug and a deeper hole for the sensor to fit.

I think these may be the type :- https://uk.farnell.com/w/c/tools-pro...ange=et-series

I have a couple of 4ETP-1 bits bought in error which you could have to prove the point if you like.

9th Nov 2018, 4:32 pm	#4
barrymagrec Octode Join Date: Dec 2017 Location: Morden, Surrey, UK. Posts: 1,560	Re: Weller WECP Temtronic bit advice please If this is the model I think it is I seem to remember that it takes bits that are virtually identical in size to the TCP bits but without the magnetic slug and a deeper hole for the sensor to fit. I think these may be the type :- https://uk.farnell.com/w/c/tools-pro...ange=et-series I have a couple of 4ETP-1 bits bought in error which you could have to prove the point if you like. Last edited by barrymagrec; 9th Nov 2018 at 4:41 pm. Reason: corrected link