View Single Post
Old 18th Sep 2019, 9:47 am   #4
David Simpson
Nonode
 
Join Date: Mar 2008
Location: Aberdeen, UK.
Posts: 2,173
Default Re: Refurbishing a Mullard Valve Tester Metalwork?

Chris,
From the time I spent near your neck of the woods, back in the 60's & 70's, Walsall, Willenhall, Wolverhampton etc. were the epicentre of specialist engineering expertise for the UK. Sadly, like the rest of British engineering, this went into decline in the last quarter of the 20th century.
However, over recent years, speaking to vintage car enthusiasts, your area has regained its status. Not only for their requirements, but also motorsport. Perhaps you should contact one or two of the vintage car forums & see who they might recommend for small metalwork restoration projects in the West Midlands. If you're successful, put out a post for others on this Forum who could benefit.

Regards, David
David Simpson is offline