Quote:
Originally Posted by Nuvistor
This is a photo of a slider pot, there are different designs but look similar. The slot in the pot is where the control knob slides along.
To clean you only need to spray a little of the Electrolube or whatever you get into that slot then work the control back and forwards. You can do this without dismantling from the top of the control panel. The spray should have a long spout to get into that slot.
Have the machine unplugged from the power and allow a little time for any of the solvents to evaporate before switching on.
|
Thank you Frank, great information there but the only problem the control panel seems to cover the slots completely, I've attached a photo, not sure if the spray will get down through it
Quote:
Originally Posted by ajgriff
The radiogram in the photo looks to me like an HFC76 or one of its close relatives. Had one a few years ago and rather regret not hanging on to it. The HFC76 was also known as the Windsor and was introduced in about 1975. The OP mentions that his is fitted with a Garrard deck which would have been an SP25 Mk IV (not like the one in the photo) in the Windsor. There should be a label with a Dynatron model number on the back of the unit somewhere.
|
Hi Alan I've had a look at the back and it is an. HFC77 so probably very similar to the model you mentioned.