Re: Philips B3G63A
Slow but steady progress - mainly chassis cleaning, cabinet cleaning, dial cord issues and general getting to know my way around...
I've noticed that some of the wiring that runs near and to the rear of the TI transformer is a bit worse for wear (see attached picture) with cracked or missing insulation - some of it had actually stuck to the transformer.
Advice please on what to replace this with or should I just consider re-sleeving the wires in question?
And what about that large resistor on the left which is a bit ropey - is that a special type (R34 1.2kΩ on Trader Sheet 1374).
|