Re: Fidelity Playmaster/Braemar Tape Recorder
@ Edward
The volume control is between V1a and V1b (ECC83) and the Monitor O/P is taken from V1b anode, so the volume control will affect the Monitor O/P.
@ ricard
The information in the R+TV service book says: "Monitor output: 400mV at 2k." With a 10K load instead, the output will of course be higher, in this case, assuming that 20V at the anode of V1b is 20V (is that about right?), it will be about 1.8V. I would think that the loading on V1a would have been taken into account at the design stage.
Many thanks for every ones comments.
Regards,
Dave.
|