UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Pellseinydd · 27th Oct 2017, 3:24 pm

Looks like the bracket that the dial mounting is clamped to - see picture.

The nut looks like that which goes on the inside end of the case fixing screw (lower centre rear of the case). There should be a spring between the fixing screw head and the case. The nut goes inside the case to stop the screw falling out when the case is opened. If you are not aware and the screw is screwed right out of the case, this nut falls loose inside the telephone.

Ian
CNet 0352 2345

27th Oct 2017, 3:24 pm	#2
Pellseinydd Heptode Join Date: Jul 2007 Location: Flintshire, UK. Posts: 707	Re: Help needed with bits! Looks like the bracket that the dial mounting is clamped to - see picture. The nut looks like that which goes on the inside end of the case fixing screw (lower centre rear of the case). There should be a spring between the fixing screw head and the case. The nut goes inside the case to stop the screw falling out when the case is opened. If you are not aware and the screw is screwed right out of the case, this nut falls loose inside the telephone. Ian CNet 0352 2345 Attached Thumbnails Last edited by Pellseinydd; 27th Oct 2017 at 3:45 pm.