18th Nov 2020, 11:21 am
|
#17
|
Dekatron
Join Date: Apr 2019
Location: Worthing, West Sussex, UK.
Posts: 6,600
|
Re: Uher CR 240 adjustments - operating point and hub tension
Quote:
Originally Posted by Uncle Bulgaria
2 - point 4.3 in the manual. I'm using a cassette I've cut slots out of with some thread tied to a hub, and a Correx 0-100p gauge in a loop. It's hard to get a consistent result, but they're all consistently lower than the manual by 20-30p. Either this is a fault in my measurement method, or the adjustment is wrong. However, with fault 1, I would have thought the tension was too high, causing it to stall at the low voltage.
|
I have never done cassette measurements but find reel to reel tension/torque measurements difficult/subjective/hit and miss.
|
|
|