Re: Uher CR 240 adjustments - operating point and hub tension
You have done well to get it working. I do not think there will be a downside as long as it works OK in Play and stops when it gets to end of tape. Difficult to say if masking an underlying fault.
Found my CR 240 (buried under loads of various R2R bits) and was going to have a look at the MP1 waveform but it will not power up, just found a wire broken off the back of the battery box connector, so need to work out where it connects to.
May be quite a while before I can check MP1 as going out soon.
David
|