View Single Post
Old 2nd Jan 2017, 4:24 pm   #35
roverp6
Triode
 
roverp6's Avatar
 
Join Date: Dec 2016
Location: Brandon, Manitoba, Canada
Posts: 46
Default Re: Tandberg Huldra 8 valve failure

Hetrodyne mentioned i should have tried 130VAC instead of the 115VAC which i used, i made a mistake here i originally wrote 110VAC it is 115VAC would running at 130VAC make a difference? i haven't checked the HT voltage because i was waiting to get the dim bulb tester made...........i would be correct to use this device to check for shorts? as you can see i have missed some steps that most of you would have done automatically, i am on a learning curve here, so you will have to bare with me on missed steps.

Clive
roverp6 is offline