UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Julesomega · 28th Jul 2019, 2:35 pm

Thanks for all answers. Maybe it's the new version 2.1.3 but there are no options for snap. I can only snap to the grid. I want to snap to the nearest 1mm while showing a 10mm grid, seems a reasonable expectation. I attach screenshots of the drop-down menus: note that the settings are under a new menu 'Options' rather than under 'Edit'

28th Jul 2019, 2:35 pm	#7
Julesomega Nonode Join Date: Dec 2012 Location: Stockport, Greater Manchester, UK. Posts: 2,106	Re: Using LibreCAD Thanks for all answers. Maybe it's the new version 2.1.3 but there are no options for snap. I can only snap to the grid. I want to snap to the nearest 1mm while showing a 10mm grid, seems a reasonable expectation. I attach screenshots of the drop-down menus: note that the settings are under a new menu 'Options' rather than under 'Edit' Attached Thumbnails __________________ - Julian It's good here Last edited by Julesomega; 28th Jul 2019 at 2:41 pm.