View Single Post
Old 14th Apr 2017, 11:08 am   #5
Lloyd 1985
Nonode
 
Lloyd 1985's Avatar
 
Join Date: Jun 2008
Location: Coningsby, Lincolnshire, UK.
Posts: 2,814
Default Re: Bush BP10 Loudspeaker cleaning

Hi,

I've had one of these apart before, it was a lot more rusty than yours though! If I remember correctly the cone is stuck to the front (flat side) with the magnet under it. As yours is working and doesn't look bad, I'd say leave well alone with regards to taking it apart. I'd probably just rub some Briwax or similar into the rust and leave it.

The screws are for the magnet, and should not be touched unless you can re-centre it. To get it apart you have to lever the front away from the back, and they are a tight fit.

These Bush BP10's sound rather good when up and running! I have 2 of them, one near mint that just needed a couple of caps changing, and a £3 basket case one that has more rust than radio!

Regards,
Lloyd.

Last edited by Lloyd 1985; 14th Apr 2017 at 11:12 am. Reason: Added info about the screws
Lloyd 1985 is offline