UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Looking for the thread describing a home made metal bender.

Refugee · 26th Nov 2017, 2:17 am

When I did metal work we had a clip you slid onto the work piece before putting it in a vice. It was simple.
If you get too ambitious there is always one of the many in this video to choose from.
https://www.youtube.com/watch?v=OYHwZCL1mPE

26th Nov 2017, 2:17 am	#13
Refugee Dekatron Join Date: Apr 2012 Location: Worksop, Nottinghamshire, UK. Posts: 5,553	Re: Looking for the thread describing a home made metal bender. When I did metal work we had a clip you slid onto the work piece before putting it in a vice. It was simple. If you get too ambitious there is always one of the many in this video to choose from. https://www.youtube.com/watch?v=OYHwZCL1mPE