View Single Post
Old 20th Feb 2021, 7:37 pm   #2
Herald1360
Dekatron
 
Herald1360's Avatar
 
Join Date: Feb 2007
Location: Leominster, Herefordshire, UK.
Posts: 15,388
Default Re: Amplion HU610. Power problem.

The barretter will act to a certain extent as a constant current limiter whereas the resistor will allow the set current to follow Ohm's law except for the current taken by any pentodes/tetrodes which are themselves fairly constant current devices.

Whether this accounts for "woolly" I don't know, but it could be interesting to compare HT volts vs heater chain volts for the resistor and barreter at similar ac supply voltages to the set.

Edit: Looked at the circuit, the barretter is only in the heater chain circuit, not the HT feed to get rectifier, so you could be getting usable heater chain current (and lamp limiter glow) at a lower HT voltage than with the resistor which could well have some effect.
__________________
....__________
....|____||__|__\_____
.=.| _---\__|__|_---_|.
.........O..Chris....O
Herald1360 is offline   Reply With Quote