Quote:
Originally Posted by DMcMahon
Subsequent to my Thread link in the Post above, I have not fully followed up on some of the suggestions.
I did file down some needle point long nosed pliers but they were not much help.
The clips I encounter although small are really strong and are really difficult to remove and replace, I use a combination of levering/prising, the ones I encounter I would say would not warp easily.
David
|
I have a pair of pliers similar to the ones in the link. Normally I use them to form loops in TCW when I'm repairing damaged PCB tracks.
At the moment I have nothing kicking around the workshop that uses E clips so cannot vouch for how effective they would be. They do look as if they would be better than needle nosed.
https://www.jewelrysupply.com/RoundC...5_p_10422.html
Al