Re: New amplifier for reel to reel
It was the high level of hiss that led me to design my own electronics for my Brenell pictured above.
Prior to this I had used a Collaro / Magnavox 363 deck with the playback section of the Practical Electronics tape link circuit. This design dated from the 70s and used an FET for high impedance input feeding a 741used for gain and EQ. It sounded ok, but sadly the noise level from a blank tape was only slightly higher than the amplifier itself!
Eventually the 363s rubber died so I started to look round for a decent 3 motor deck to try my own ideas out. I found the Brenell and built an op-amp based playback pre-amp. This was much quieter than the PE design. Eventually I also added full featured record amplifiers.
|