If you don't mind the expense I can recommend these boards
http://www.roadrunnerelectronics.com...Boards/Oktapad
The are very well made, have nice pads and stand up to heat well. I've tried cheaper ones but to get the enamel to melt you need the iron HOT and when prototyping I end up re-doing joints over and over ending in lifted pads. The reverse has a nice ground plane too.
I can also recommend their wiring pens (and kits) the wiring pen has a metal nozzle (rather than the plastic one on the vero which I, of course, quickly melted!)
The also do the combs but I didn't bother with them and went rat's nest as this was a "make it up as you go along" project...
https://stardot.org.uk/forums/viewto...=15350#p210135
D