Thread: Aurora fault.
View Single Post
Old 31st Jul 2018, 4:07 pm   #8
tubesrule
Hexode
 
tubesrule's Avatar
 
Join Date: Jul 2004
Location: Michigan USA
Posts: 325
Default Re: Aurora fault.

Just to chime in:
If the modulated output is working properly than the line level driver must be in working order as that's what's used to drive the modulator. There is a 75 ohm terminating resistor in series with the jack that could conceivably be bad. It would be worth a check. If it checks out good as does the jack, then possibly the cabling or device it's connected to is presenting the fault.

Darryl
__________________
Aurora video standards converters: http://www.tech-retro.com/Aurora_Design/Video_Home.html
tubesrule is offline