UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

nigelr2000 · 21st Jul 2019, 5:52 pm

Check the little copper or plastic washer is in position in the idler assembly as this can cause it to stick when changing directions if its not there, goes on the shaft after the f/r idler and before you drop the top of the idler assembly on (the belt drive bit). alos seem to remeber there are washers top and bottom but its been a while since I did one.

21st Jul 2019, 5:52 pm	#19
nigelr2000 Heptode Join Date: Nov 2008 Location: North Walsham, Norfolk, UK. Posts: 900	Re: Sanyo VTC5000 problems when cold only Check the little copper or plastic washer is in position in the idler assembly as this can cause it to stick when changing directions if its not there, goes on the shaft after the f/r idler and before you drop the top of the idler assembly on (the belt drive bit). alos seem to remeber there are washers top and bottom but its been a while since I did one. __________________ https://www.facebook.com/gntrading Last edited by nigelr2000; 21st Jul 2019 at 5:57 pm. Reason: spelling and better description