UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Copicat MK2

Michael Why · 15th Mar 2019, 11:08 pm

I had replaced 2 of the 25uf's but was missing the other two which arrived today , I replaced those and also used the switch block ( with new resistors ) from the other copicat , both made a little improvement

Its a bit noisy but i have all the components stood up off the board so i can get at them so all the long leads are probably acting like antenna's. now its pretty much working i will fit these properly and see what its like

Cheers

Mike

15th Mar 2019, 11:08 pm	#34
Michael Why Retired Dormant Member Join Date: Nov 2017 Location: Newcastle upon Tyne, Tyne & Wear, UK. Posts: 18	Re: Copicat MK2 - No Echo I had replaced 2 of the 25uf's but was missing the other two which arrived today , I replaced those and also used the switch block ( with new resistors ) from the other copicat , both made a little improvement Its a bit noisy but i have all the components stood up off the board so i can get at them so all the long leads are probably acting like antenna's. now its pretty much working i will fit these properly and see what its like Cheers Mike