UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Simple method to mark calibration and functions externally on a case?

Ian - G4JQT · 18th Feb 2018, 2:41 pm

This is my recent (if unimaginative) attempt using MS Word and a laminator.

Some of the lettering is not quite in the right place, which I'm sure will probably irritate me enough to get me to redo it in coming days!

I'm afraid I didn't have the patience to add the frequency calibration properly - it's hand written. But something else I may well correct in the MkII.

18th Feb 2018, 2:41 pm	#33
Ian - G4JQT Octode Join Date: Jun 2004 Location: Reading/Fakenham, UK. Posts: 1,323	Re: Simple method to mark calibration and functions externally on a case? This is my recent (if unimaginative) attempt using MS Word and a laminator. Some of the lettering is not quite in the right place, which I'm sure will probably irritate me enough to get me to redo it in coming days! I'm afraid I didn't have the patience to add the frequency calibration properly - it's hand written. But something else I may well correct in the MkII. Attached Thumbnails Last edited by Ian - G4JQT; 18th Feb 2018 at 2:46 pm.