Re: PCB TONER method revisited
You really need matt white Fablon, so you can stick the Fablon on the laminate, then use a pencil or ‘Sharpie’ and a straightedge to draw out your design on the Fablon. Then you can cut out the design with a craft knife, remove the waste areas, leaving the rest of the design on the laminate as the etch resist.
Then after etching, peel off the remaining Fablon.
I think you should be able to get Matt white Fablon on Amazon in Canada.
Hope that helps.
__________________
David.
BVWS Member.
G-QRP Club member 1339.
|