View Single Post
Old 26th Dec 2017, 10:10 pm   #13
Ksdavies
Retired Dormant Member
 
Join Date: Dec 2017
Location: Thornton Cleveleys, Lancashire, UK.
Posts: 15
Default Re: Gould 1604 plotter

Re: Gould 1602/04

I've just obtained a 1602 as well as my 1604 but it had very bad focus issues so I changed the 10uF caps on the power supply, as mentioned in a previous posting, and the results were very good. I switched off the 1602 and carried on changing the caps on the 1604.

Later I switched on the 1602 and got nothing just as though a fuse had blown. I tested the mains fuse and also the two on the power supply board and all were OK. It states in the repair manual that there is a fast blow fuse on the rear panel but I can't find one. Any help would be appreciated.
Ksdavies is offline