Re: Roberts RMB Problems
That's a very useful bit of information, Ron, many thanks! So much for Trader service sheets...
Dave, try disconnecting the wire from the right-hand corner of the bridge rectifier, where the anodes of the two diodes join, from chassis, then reconnect C26 and see what happens. See if you can find the tapped voltage adjuster shown in Ron's photo.
__________________
Phil
Optimist [n]: One who is not in possession of the full facts
Last edited by Phil G4SPZ; 12th Oct 2014 at 9:57 pm.
Reason: Typo
|