Advance TP2B termination
Hi
Would anyone either have an ADVANCE TP2B termination lead or a diagram so that I can build one All expenses reimbursed Many thanks |
Re: Advance TP2B termination
I have information on the TP1B. Not sure how much the TP2 differs.
Al |
Re: Advance TP2B termination
The TP2B in the termination lead used in conjunction with an Advance Sg-62 sig Generator, I am not sure what the difference between the TP1B and the TP2B is
If my memory serves me right, the lead was approx. 2ft long with a 2.5" long by 1.5" wide and about 1" deep with provision for banana plugs, I am hoping to possibly make one using some better RF connectors instead of the banana plugs. Is your information suitable for an email Regards Bill |
Re: Advance TP2B termination
The only thing I can think of is that the TP1B is 75R. Perhaps the TP2B is for 50R termination. Incidentally the B is for Belling Lee sockets. The original TP1 had a different connector.
PM me an email address, I will send what I have. Al |
Re: Advance TP2B termination
Hi
As you had mentioned a TP1B, I googled it, and it up with a circuit of the unit, it looks like the one that I used to use 30 odd years ago, it's 75 ohms so I will find a small box and make one up, I still feel that my one had a lead on the end but I could be wrong. Thanks for the reply and your time Regards Bill |
All times are GMT +1. The time now is 7:36 am. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.