What would happen if I made an MW pantry TX aerial like this ?
Basically , for use around 1.5MHz, an antenna made of say 4 metres of coax but with the Earth braid outer swapped ... outer braid to the load and the core as ground , then the termination connected with a 50R resistor.
???? |
Re: What would happen if I made an MW pantry TX aerial like this ?
It would radiate a weeny bit, most of the power would be dissipated in the 50 ohm resistor.
|
Re: What would happen if I made an MW pantry TX aerial like this ?
Hi Al, and you might get a lobe from your 50R depending on its type and if screened.
Ed |
All times are GMT +1. The time now is 1:50 pm. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.