When an Avominor needle loses it's red disc.
3 Attachment(s)
At certain positions on the scale a Universal Avominor needle is almost invisible once it has thrown it's 'dot'- so it was a case of having a bash at attaching a new dot.
As far as i know the Model 1 pictured (400ohm/volt) always had a dot- but i am not so sure about the Model 2. (4,000ohm/volt) On assessing the nose/tail balance i noticed the needle was nose-light to the extent that it sat at 4% of FSD (with the scaleplate zero line aligned horizontal.) Conveniently the self-adhesive vinyl black dot plus araldite applied underneath rectified the balance. The dot is about 1.5mm across! (Trial placing relied on the tackiness of the adhesive backing, then i applied glue.) The calibration of the magnet needed to be raised slightly- presumably to compensate for the dynamics of the new arrangement. Dave |
All times are GMT +1. The time now is 3:44 pm. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.