Speaker cabinet refurbishment.
2 Attachment(s)
I need to tidy these speakers up a little, I just need some advice of treating the cabinets. They are marked as can be seen, and they are rough to touch. I was going to use some stain and danish oil, however how do I remove the stains ect. It is veneer over chipboard.
|
Re: Speaker cabinet refurbishment.
Wipe over with white spirit to see what they will look like when varnished.
If still poor, then the existing finish will need to be removed and the surface smoothed. The veneer could be very thin and is easily rubbed through. |
Re: Speaker cabinet refurbishment.
Treat them with scratch cover polish (a few brands available, just google it). You may find that that is enough. If it isn't, sand down and refinish using Wilko quick dry satin varnish.
|
Re: Speaker cabinet refurbishment.
I've used this stuff on tables, chairs and other furniture - available for various wood types: -
https://www.amazon.co.uk/Howard-RF10...type=ss&sr=1-1 |
Re: Speaker cabinet refurbishment.
Rub down with fine wire wool then treat with Danish oil? I have had good results on a water stained coffee table using this method.
|
Re: Speaker cabinet refurbishment.
That looks like teak to me so oil is the right finish. Best not to stain it.
|
Re: Speaker cabinet refurbishment.
I'd definitely go the oil way. Either Teak Oil or Danish Oil. Could be worth trying it out on the bottom of the cabinet first, so you get a feel for the absorbency of the wood and to what extent the colour changes when the oil is absorbed.
Personally, I like Danish Oil because it leaves a matt, not shiny finish. |
Re: Speaker cabinet refurbishment.
There seem to be several formulations of both teak and Danish oil based on linseed oil with additives to hasten drying. I bet that at extremes the formulations overlap. I have had very good results from Danish oil including on a "slate" clock!
|
Re: Speaker cabinet refurbishment.
Beware when using these oils. The rag you used to apply it can be a fire hazard by spontaneous combustion. Linseed is notorious.
David |
Re: Speaker cabinet refurbishment.
Fireworks! Will be carefull thanks. The only thing I am concerned about is I will be left with patches as there is already, I would assume I will have to get them a even colour in the first place.
Thanks for the comments so far. |
Re: Speaker cabinet refurbishment.
Quote:
The solution is to open the rag out, and not leave it wadded up in a lump. Craig |
Re: Speaker cabinet refurbishment.
I didn't know this, after googling and watching a video I feel stupid not knowing.
|
Re: Speaker cabinet refurbishment.
I have treated patchy surfaces with fine wire wool followed by several coats of Danish oil with good results. The more problematical area could be the partly faded panel in the second photograph. There will always be some shading but that happens with wood anyway. Could you try a less visible area first?
|
All times are GMT +1. The time now is 4:30 am. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.