Nombrex 32 bridge
5 Attachment(s)
HI,
I wanted to put this in the thanks thread,but not sure if one can put in pictures. Success/thank you story I wish to thank (Glyn Welsh Anorak) for the Nombrex C.R.32 Test Bridge he gave me on the 7th of March. The first problem was to get the knobs off as the grub screws were rusted solid, so I WD-40 them and left them a couple of days and I had to force them off. I then ordered some more new control knobs. While waiting for the above knobs to arrive I got on with the next problem to replace the three transistors, as the HV oscillator was not working (2g371)and the two amplifier transistors (2g374) had corroded legs, I did not have any of these so I put in place 2N3906,s and replaced the (2x10uf caps) and the (100uf Lt cap) Then cleaned all controls and Sprayed cabinet, tested and waited for knobs to arrive. It is now fully functioning with new knobs. A nice little Instrument to go with my Lafayette CR analyzer TE-46. Heathkit IB-5281 RLC Bridge. Hameg L.C. meter HM.8018. Thanks again Glyn.:thumbsup: gezza123 |
Re: Nombrex 32 bridge
That has a very pleasing appearance.
I've seen quite a few of these, but usually battered & scratched. I think the original knobs were a bit smaller, but it looks better proportioned now. Not lab-grade, but jolly useful. |
Re: Nombrex 32 bridge
4 Attachment(s)
Hello.g4aaw pete.
Thank you for your comment, yes I am very pleased with it. Yes you are correct about the original knobs being smaller as they had a 25mm skirt and 18mm hat, the new ones are 28mm skirt and 23mm hat, so well spotted. Here are some pictures of before. cheers gezza123 |
All times are GMT +1. The time now is 2:40 pm. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.