UK Vintage Radio Repair and Restoration Discussion Forum

UK Vintage Radio Repair and Restoration Discussion Forum (https://www.vintage-radio.net/forum/index.php)
-   Hints, Tips and Solutions (Do NOT post requests for help here) (https://www.vintage-radio.net/forum/forumdisplay.php?f=22)
-   -   Stuck Ferrite IF cores. (https://www.vintage-radio.net/forum/showthread.php?t=169455)

FrankB 28th Jul 2020 7:06 am

Stuck Ferrite IF cores.
 
We all have run into this from time to time.
I ran into a lot of this in TV servicing and old radios.

That "delightful" hex hole core was stuck. Often from hot glue, or more commonly beeswax or silicone seal.

Getting a stuck core out can try the patients of a Doctor (LOL).

I found sometimes pouring some denatured alcohol into the core would loosen it, but more often digging out the silicone seal, or hot glue- and heating the coil carefully with a heat gun to melt the bees wax out.
Sometimes putting in a nail filed to the core shape and heated would loosen the beeswax quite quickly too.

Then comes that sound we all dread... Crunch! When the core breaks into a pile of ferrite pieces.
I learned decades ago that this was way more common than I liked. So I started removing the adjustable ferrite cores from old TV and radio chassis, 2 way radios, etc.
I would carry a box of them of assorted diameters and lengths in my service kit. (GC- General Cement, used to make a kit of assorted replacement cores).

The core you need too long? File it down or use sand paper to reduce the length. Too short? Put 2 cores snug with each other, and cement together with ferrite cement. Then put in the coil form.

Now I never found any problem with ferrite mix causing a problem in the coils. Sometimes I'd have to adjust the core to a different spot to get the correct adjustment, due to the replacement core being a bit longer, shorter, etc; but it never failed me.

Oh, and carry a few VERY thin rubber bands in your kit too. Some cores used a thin strip of rubber band to "lock" the core in place. No glue, silicone, or beeswax needed. I did carry a small ball of bees wax to seat the cores with and wax dial cords too.

The very last thing I wanted to do was replace a good coil with a replacement just because of a broken core.

SeanStevens 28th Jul 2020 8:54 am

Re: Stuck Ferrite IF cores.
 
I have a transistor radio that needs 3 or 4 cores replaced. They are not broken yet, but will be if I try any harder to get them out.

Does anybody sell slug replacement sets still?

SEAN

Tractionist 29th Jul 2020 2:06 pm

Re: Stuck Ferrite IF cores.
 
Some people also recommend eardrops [i.e. those intended to dissolve and/or dislodge wax] .........? Hear! Hear! :laugh1::laugh1::laugh1:


All times are GMT +1. The time now is 6:20 am.

Powered by vBulletin®
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Copyright ©2002 - 2020, Paul Stenning.