GEC SA9083 Tester (ex BT)
Good morning, my first post here!
I am looking for some information on my SA9083 tester. I have had it several years just using the ohms ranges. This all works fine, as does the M Ohms range. It will not however measure voltage on the 5V DC range, or the AC250V (Off) setting. I suspect an open circuit resistor or diode somewhere as I cannot measure any internal resistance through the meter terminals on these settings. Can the circuit diagram be purchased for this meter? If I knew the rotary switch connections it would help me to trace the circuit. I can't find any fuses inside. It was made around 1990 by GEC measurements (SEI) and is the version with the 9V battery. Thanks in advance. Mark. |
Re: GEC SA9083 Tester (ex BT)
Hi Mark,
I believe the information you need is available FOC from https://elektrotanya.com/robin-teste.../download.html |
All times are GMT +1. The time now is 12:14 pm. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.