UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > Specific Vintage Equipment > Vintage Television and Video

Notices

Vintage Television and Video Vintage television and video equipment, programmes, VCRs etc.

Reply
 
Thread Tools
Old 19th Jun 2017, 7:28 pm   #61
Dave Moll
Dekatron
 
Dave Moll's Avatar
 
Join Date: Feb 2005
Location: West Cumbria (CA13), UK
Posts: 3,024
Default Re: Pre-war television aerial spotting

The accompanying text about the aerial says:
Quote:
To the lower end of the aerial a two-wire feeder should be joined, but only one wire is connected to the aerial end. The second one is left quite free and runs parallel to the feeder wire over the whole of its length. The distance between the wires must be kept approximately the same - about two inches is quite satisfactory - and to ensure a parallel run over the whole length it is necessary to insert insulating distance pieces at regular intervals. Keep this double feeder as clear as possible from buildings, and, furthermore the feeder must be tuned, a process effected very simply by lengthening or shortening the feeder at the set end where it joins the input terminals of the set. A little patient experiment will be necessary in order to determine the optimum conditions for length and position, but once this has been done the results from the point of view of maximum signal strength picked up should be highly satisfactory.
Make of it what you will.
__________________
Mending is better than Ending (cf Brave New World by Aldous Huxley)
Dave Moll is offline   Reply With Quote
Old 19th Jun 2017, 9:22 pm   #62
Nuvistor
Dekatron
 
Nuvistor's Avatar
 
Join Date: Aug 2013
Location: Wigan, Greater Manchester, UK.
Posts: 3,996
Default Re: Pre-war television aerial spotting

What about the orginal single wire Windom?
http://www.w8ji.com/windom_off_center_fed.htm

Frank
Nuvistor is offline   Reply With Quote
Reply

Thread Tools



All times are GMT. The time now is 12:41 am.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright ©2002 - 2017, Paul Stenning.