|
Television Standards Converters, Modulators etc Standards converters, modulators anything else for providing signals to vintage televisions. |
|
Thread Tools |
21st Mar 2015, 2:09 pm | #1 |
Dekatron
Join Date: Mar 2005
Location: Gateshead, Tyne and Wear, UK.
Posts: 7,444
|
Aurora works well on six volts.
I'm trying out two new Aurora SCRF405 standards converters on a six volt supply. No problems whatsoever. The power suppliers are from defunct Pace Freeview boxes, the very early strange shaped unit that was made not long after the introduction of digital TV in the UK.
DFWB. |
22nd Mar 2015, 12:36 pm | #2 |
Dekatron
Join Date: Mar 2005
Location: Gateshead, Tyne and Wear, UK.
Posts: 7,444
|
Re: Aurora works well on six volts.
As a follow to my last post about operating the Aurora on a 6 volts supply. Although it would appear the converter will operate on such a low supply voltage, it is unwise to do so. Nine volts is the recommended supply.
The reasons for not operating the Aurora on less than 9 volts is explained here: http://forum.radios-tv.co.uk/viewtop...112939#p112939 DFWB. |
25th Mar 2015, 11:16 pm | #3 |
Hexode
Join Date: Mar 2014
Location: Dublin, Ireland
Posts: 398
|
Re: Aurora works well on six volts.
I run my auroras off stabilised 7.5v with no problems - I found that at 9v they run hotter than I would like - I also use external heat sinking on 'F' connectors which I have found to be very effective.
I appreciate that some may regard this as overkill but I believe it helps if equipment is run as cool as possible John |
26th Mar 2015, 5:10 am | #4 |
Dekatron
Join Date: May 2008
Location: Derby, UK.
Posts: 7,735
|
Re: Aurora works well on six volts.
I think you got lucky running it from a 6 V supply; the regulator is just on the bounds of its sensible operating region. If you were on a real milliwatt-saving trip, you could get a 5V regulated switched-mode plug-top PSU and bypass the Aurora's regulator. Using a micro-USB connector for the regulated supply would reduce the risk of plugging in an incorrect PSU.
__________________
If I have seen further than others, it is because I was standing on a pile of failed experiments. |
26th Mar 2015, 10:59 pm | #5 |
Nonode
Join Date: Jan 2004
Location: 1966-1976 Coverack in Cornwall and Helston Cornwall. 1976-present Bristol/Bath area.
Posts: 2,967
|
Re: Aurora works well on six volts.
I use a switched linear psu on mine and find that I get a 9v output to the aurora with the PSU switched to 7.5v output.The Aurura now runs much cooler and it's nice to know that I am feeding it the correct voltage.
__________________
Simon BVWS member |
26th Mar 2015, 11:50 pm | #6 |
Dekatron
Join Date: Mar 2008
Location: Worthing, West Sussex, UK
Posts: 5,185
|
Re: Aurora works well on six volts.
Although you can run the Aurora at 12v, it is much happier at 9v. I run mine on a good quality regulated supply. The voltage under load is was 8.9 volts.
The cooler it runs the longer it will last! Mark |