Re: Homebrew Valve Tester
Edward,
Here as promised are some photos of the valve holder panel and the front panel.
Fortunately the case I used was 300mm wide, so I could use A4 paper for the front panel (I ignored the 1.5mm difference either side - homebrew engineering tolerence!!) as it was a simple solution to getting a decent looking panel.
Although the wiring looks a nightmare, use coloured wiring (Rapid Electronics do small packs of both solid and multi core wire) and wire up each colour in turn.
If anyone is interested, I can do printed circuit diagrams, but I woukld like these to be used only for pivate NOT COMMERCIAL use without my permission.
Mike
|