Re: Trio W-38 servicing process
I would expect this set to have all the valve heaters wired in parallel, so if two valves didn't light up either thay had blown heaters or there is/was a fault in the heater wiring.
I would start by checking the heaters of the non glowing valves for continuity. If this is OK, then suspect a fault in the heater wiring. Either a short circuit or contact with earth would tend to overload the transformer.
I would also carefully check the work you've done and perhaps reform any high voltage electrolytics.
__________________
Graham. Forum Moderator
Reach for your meter before you reach for your soldering iron.
|